{"id":85,"date":"2026-11-11T15:45:21","date_gmt":"2026-11-11T10:15:21","guid":{"rendered":"https:\/\/rattanagrotech.com\/blog\/rotavator-off-season-storage-guide\/"},"modified":"2026-11-11T15:45:21","modified_gmt":"2026-11-11T10:15:21","slug":"rotavator-off-season-storage-guide","status":"publish","type":"post","link":"https:\/\/rattanagrotech.com\/blog\/rotavator-off-season-storage-guide\/","title":{"rendered":"Rotavator Off-Season Storage Guide: Put It Away Right, Start Next Season Faster"},"content":{"rendered":"\n

Once the season’s tillage is done, most rotavators sit idle until the next sowing. How you put the machine away decides how it starts next season. A rotavator parked in the open with mud on the blades and a dry PTO shaft often comes back with rust, seized parts and lost days. One that is stored right is ready the morning you need it.<\/p>\n\n\n\n

This guide gives you two short checklists: one for putting it away<\/strong> at the end of the season, and one for bringing it back<\/strong> before the next one. For the basics of the machine, see our rotavator guide<\/a>.<\/p>\n\n\n\n

\n\n\n\n1<\/text>\nWORK<\/text>Season’s<\/text>tillage<\/text>\n2<\/text>\nPUT AWAY<\/text>Clean, grease,<\/text>protect<\/text>\n3<\/text>\nREST<\/text>Under a shed,<\/text>off the ground<\/text>\n4<\/text>\nBRING BACK<\/text>Check,<\/text>test run<\/text>\n<\/g>\nA little time at steps 2 and 4 saves days later.<\/text>\n<\/svg>\n<\/div>\n\n\n\n

Part 1: Putting it away (end of season)<\/h2>\n\n\n\n

Do this within a day or two of the last field, while the mud is still soft and any damage is fresh in your mind.<\/p>\n\n\n\n

\"Rattan
Clean the rotor, blades, hood and levelling board before storage.<\/figcaption><\/figure>\n\n\n\n
    \n
  1. 1<\/span>
    Clean off all mud and straw.<\/strong> Wet soil and crop residue packed around the rotor and inside the hood hold moisture against the steel. Scrape and wash it out, then let the machine dry fully before storing.<\/div><\/li>\n
  2. 2<\/span>
    Inspect every blade.<\/strong> Look for worn, bent or cracked L-type blades. Replace them now, when you have time, rather than in the rush of the next season. Order spares early.<\/div><\/li>\n
  3. 3<\/span>
    Tighten all nuts and bolts.<\/strong> Blade bolts, hitch points, skid and board fixings all loosen over a season of vibration.<\/div><\/li>\n
  4. 4<\/span>
    Grease every grease point.<\/strong> Fresh grease pushes out old grease and any water that has got in, and protects bearings during the idle months.<\/div><\/li>\n
  5. 5<\/span>
    Check the gearbox oil.<\/strong> Check the level, and change or top up the oil as given in your machine’s manual.<\/div><\/li>\n
  6. 6<\/span>
    Protect bare metal.<\/strong> Touch up chipped paint. Wipe a light coat of oil on bare steel that cannot be painted, such as worn blade surfaces, to slow rust.<\/div><\/li>\n
  7. 7<\/span>
    Remove and store the PTO shaft.<\/strong> Take it off, clean it, grease it, and keep it in a dry place with its guard in good shape.<\/div><\/li>\n
  8. 8<\/span>
    Park it right.<\/strong> Store it under a shed, resting on wooden blocks or a stand so the blades are off the ground, and cover it. Keep it away from fertiliser bags, which can speed up rust.<\/div><\/li>\n<\/ol>\n\n\n\n
    \"Hitch
    The hitch and PTO end: take the shaft off, clean and grease it, and store it dry.<\/figcaption><\/figure>\n\n\n\n
    Make a note while you store it.<\/strong> Write down anything that needs a part or repair: a blade count, a worn skid, a bent board. Keep the note with the machine or on your phone so you can order parts in the off-season instead of at sowing time.<\/div>\n\n\n\n

    Part 2: Bringing it back (start of season)<\/h2>\n\n\n\n

    Start a week or so before you need the machine, so there is time to get a part if something is missing.<\/p>\n\n\n\n

    \n
    Oil and grease<\/div>
    Check the gearbox oil level again and look for leaks under the machine. Give every grease point a fresh shot.<\/div><\/div>\n
    Blades and bolts<\/div>
    Fit any spares you noted. Check every blade bolt and the hitch bolts once more.<\/div><\/div>\n
    Board and skids<\/div>
    Make sure the levelling board moves freely, its springs are fine, and the depth skids adjust without sticking.<\/div><\/div>\n
    PTO shaft and guard<\/div>
    Refit the shaft, check that it slides freely and the guard is complete. Never run without the guard.<\/div><\/div>\n<\/div>\n\n\n\n
    \"Rear
    Check that the rear levelling board moves freely before the first field.<\/figcaption><\/figure>\n\n\n\n
    Do a short test run.<\/strong> Hitch up and run the rotavator at low PTO speed with the machine lifted, with everyone standing well clear. Listen for unusual noise and watch for vibration or leaks. Stop the tractor and PTO before you touch anything. If something does not sound right, see our Rotavator Problems and Fixes<\/a> guide or call us.<\/div>\n\n\n\n

    Common storage mistakes<\/h2>\n\n\n\n
    \n
    Avoid these<\/div>\n
    \n

    \u2717 Leaving it in the field or open yard.<\/strong> Sun and rain over months do more harm than a full season of work.<\/p>\n

    \u2717 Storing it dirty.<\/strong> Dried mud traps moisture and hides cracks you would otherwise have seen.<\/p>\n

    \u2717 Resting it on the blades on bare soil.<\/strong> Damp ground rusts the blades and the rotor.<\/p>\n

    \u2717 Leaving the PTO shaft on the machine in the open.<\/strong> The sliding parts can rust and stick.<\/p>\n

    \u2717 Waiting until sowing day to check it.<\/strong> That is the worst time to find you need a part.<\/p>\n<\/div>\n<\/div>\n\n\n\n

    \"Side
    Side drive cover and depth skid: clean around them and check for leaks before storage.<\/figcaption><\/figure>\n\n\n\n

    Frequently asked questions<\/h2>\n\n\n\n
    Should I wash the rotavator with water before storing?<\/summary>

    Yes, washing off mud is fine, but let the machine dry completely before you grease it, oil bare metal and cover it. Covering a wet machine traps the moisture.<\/p><\/details>\n

    Which gearbox oil and how much?<\/summary>

    Use the oil grade and quantity given in your machine’s manual. If you do not have the manual, call us with your model and we will tell you.<\/p><\/details>\n

    Can I keep the rotavator attached to the tractor?<\/summary>

    For a long idle period it is better to unhitch it and rest it on blocks or a stand. That keeps the weight off the tractor’s hydraulics and keeps the blades off the ground.<\/p><\/details>\n

    Where can I get spare blades?<\/summary>

    Contact us for genuine hardened carbon steel L-type blades for the Rattan rotavator. Ordering in the off-season means you are not waiting at sowing time.<\/p><\/details>\n\n\n\n

    More on the rotavator:<\/strong> Complete guide<\/a> \u00b7 Problems and fixes<\/a> \u00b7 Buying checklist<\/a> \u00b7 Myths vs facts<\/a><\/p>\n\n\n\n

    Need spares before next season?<\/h3>

    Ask us about blades, servicing advice or a new rotavator. You can talk to us in Punjabi or Hindi too. \u0a24\u0a41\u0a38\u0a40\u0a02 \u0a38\u0a3e\u0a21\u0a47 \u0a28\u0a3e\u0a32 \u0a2a\u0a70\u0a1c\u0a3e\u0a2c\u0a40 \u0a35\u0a3f\u0a71\u0a1a \u0a35\u0a40 \u0a17\u0a71\u0a32 \u0a15\u0a30 \u0a38\u0a15\u0a26\u0a47 \u0a39\u0a4b\u0964<\/p>

    Get Price Quote<\/a>WhatsApp Us<\/a><\/div><\/div>\n","protected":false},"excerpt":{"rendered":"

    Two simple checklists for your rotavator: what to do when you put it away at the end of the season, and what to check before the next season starts.<\/p>\n","protected":false},"author":1,"featured_media":84,"comment_status":"closed","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":{"footnotes":""},"categories":[6,7],"tags":[],"class_list":["post-85","post","type-post","status-publish","format-standard","has-post-thumbnail","hentry","category-farm-machinery","category-farmer-tips"],"_links":{"self":[{"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/posts\/85","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/posts"}],"about":[{"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/types\/post"}],"author":[{"embeddable":true,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/comments?post=85"}],"version-history":[{"count":0,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/posts\/85\/revisions"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/media\/84"}],"wp:attachment":[{"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/media?parent=85"}],"wp:term":[{"taxonomy":"category","embeddable":true,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/categories?post=85"},{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/rattanagrotech.com\/blog\/wp-json\/wp\/v2\/tags?post=85"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}